Q: Im not sure of the process of going through this, but this is what I did.
I got a new computer, so I tried throwing in the HD of my old ocmp in my new comp. restart walked Seagate wizard (its a Seagate), but it does not recognize the HD altogether. Went into BIOS to see if I could do anythign but it gives me no other options besides “OFF”. So after messing with it for aa while and try to get it working and I Giave deicided to throw back in the old comp and just use. But when I now him back in the old comp that gave me the same error! Someone help!
Web based computer repair
Re:Were you trying to boot from the new system with the old hard drive? Or were you trying to install it as a slave drive in the new computer??
Beginners Computer Tutorial.
Re:Im betting the mother board drivers on the old operating system conflict with new system. Heres my thoughts on it. (based on it booting to the safe mode part)
You can
1-get another drive and install operating system on it, using the old drive as a d:Drive
2-delete windows dir in dos. and reinstall windows on that drive(not a great idea)
3-try to get the drivers for the new motherboard(including drive conrollers ect) installed, probably have to do on your old system. This is a big pain…its sometimes possible though if you must do it.
Blade
New* Fast PC Secrets – Eliminate Slow Computer Problems 13 Vids
Re:what channel to you have it plugged in to and what are your jumper settings?
Computer Secrets Unleashed! 2009
Re:I got the old system to run again, but when I retried the new system with my old HD it DID recognize it but it would show boot up option screen where I can load Safe Mode or Continue Normally in which either choice just send it back into a loop of restarting and going through the whole process all over again.
Best Computer Monitoring Software
Re:You may have a bad IDE/SATA cable, a bad power connector, or a bad disk controller on the motherboard. Do you have another system in which to test?
0 Comments.