Q: Im running a Duron 600 @ 1000 in this system and Im now moving up a
to 1g. AXIA (bridges unlocked)
Would someone please remind me what exactly I need to do to this setup to run at
say . . 1.3
I have 256 of the PC133
Also, a Cooler Master DP5-5H51 sufficient cooling with the o / c? (I have a Delta
screamer but I do not want it again). I have 6 case fans running too.
Thanks in advance, guys.
Jeff
Re:my bad…. i was thinking you had a kt7a
as was said above… the kt133 chipset will rarely run over 110mhz
Re:guyBW
Thanks man.
Jeff
Re:you can also get the latest BIOS for the board from www.abit.com.tw (http://www.abit.com.tw) which has a "12above" multiplier, which is 13. I am running my KT7 with a 1g Axia at 1430MHz (13*110), although some people can not get more than about 105 from the FSB.
guyBW
Re:Set the multiplier to 12.5 and vcore to 1.775v. KT7 will boot CPU at 1300 (12.5*104). It ups the FSB to 104 on its own and will give you 1300. Many people have reported this and it works on mine.
Re:<< Umm, one correction, there isn't much of a chance you are gonna get to 133 mhz fsb, if that is an original KT7-Raid (without the A), look @ a max of say 110-115, if that…
Try setting it to 12.5x 105-7….right around 1.3 (a bit higher)
….
correct me if i'm wrong.. >>
You, know, that's what I was thinking. I am relatively new to all of this but I thought I could remember that from some where, thus the reason for this post. I do know that I am runnung @ 100fsb X 10.0 right now.
Thanks for posting, we'll see, wont we? BTW it is KT7 w/o the A. And, also, 1.3 is what I was shooting for anyway.
Thanks,
Jeff
Re:Umm, one correction, there isn't much of a chance you are gonna get to 133 mhz fsb, if that is an original KT7-Raid (without the A), look @ a max of say 110-115, if that…
Try setting it to 12.5x 105-7….right around 1.3 (a bit higher)
….
correct me if i'm wrong..
Re:Thanks, to another southern boy.
Re:you may or may not need to increase the core voltage (1.75 is default)
set the fsb at 133mhz and set the multiplier at 10x 
not to hard
0 Comments.