Q: I have this problem where my keyboard works with the computer most of the time, but then at times, its just entirely cut off the keyboard and I have to re-insert plug.
Is there a way to correct? It is not so important, just very annoying.
Q: Hi just built my first
I system, and the ChromeOrb used
there I was kind of a rubbery patch where it connects to
the Athlon. I just sit and now I get about 68c.
I feel this way too high, should I remove rubberythingy
and put some Arctic Silver instead?
Athlon Socket 800 (stock speed)
Asus A7V with 1004c bios
ChromeOrb cooler
What temps are reasonable? 45? 55?
TIA, Tome
Q: If I setup for NT or Win2K I get this u0026quot, Setup can not find hard drive or a mass storage . Check all cables run . etc. u0026quot; . Im running an Asus A7V mobo, DiamondMax ATA 100 30 gig drive, I do not understand . I installed 98 fine . but when it comes to the real OSs . Can not get past that . I have Maxtor ATA 100 driver from web site . told you extract it with the d switch to dos . So I did . ATA100-d and extracted . (I do not know what ad-switch .: o) and it seemed to work . So
Q: Do my chances with 600650700 or higher? I hope to hit 950 at least if not an act. Just got an Asus A7V mobo and would like to deploy a Duron. I know her first as the CPU, the speed issue, but that speed hits more frequently occur?
Q: Ok, I went on my Asus A7V 98SE, an integrated Promise ATA100 IDE controller . I have two HD, one on each ATA bus, and a CD-ROM and a CD-R on the two IDE channels. All this worked fine until I tried to go to Win2K. Ive heard there were problems with the ATA100 under win2k, but it is so long you had the latest drivers and the work I update the bios. 2K after reboot my system to install, it says cannot find any HD to install . So I gave up for now 2K,
However now I cannot boot unless
Q: I recently installed Win2k Pro on a new ATA100 HD. The ATA100 HD is connected to the primary ATA connector on my ASUS A7V MB and the secondary IDE connector is plugged into my CD-ROM (secondary master) and an internal ZIP drive (secondary slave). Since last week, everything works great. I installed Half-Life off of a CD about a week ago. However, last night, I went to install something else and discovered that both my CD-ROM and ZIP drive does not appear under Win2k. The bios recognize that t
Q: I have a problem with a 40GB Western Digital I bought a while back. The drive is ATA100 and my motherboard (ASUS A7V) has two IDE connectors (primary / secondary) and two ATA100 connectors (primary / secondary) and came up with a 80connector ATA100 cable. when my hard disk to the motherboard and go to the movies, it never finds the drive. I tried the disc on the ATA100 connectors and the IDE connectors and the ribbon cable and a 80connector 40connector ribbon cable. My CD drive is on the seco
Q: Hey guys, Im using the ASUS A7V for about 2 months, I can not the FSB is very unstable, I have my 900 on TBIRD 10.5×100 . So I sold my A7V to a friend and ordered the abit kt7a . I hope to see atleast 140×7.5 . Im using key 133 @ 144 2-2-2 . I was thinking of picking up a stick of mushkin rev3 and pushing it to 160 2-2-2 . what do you think about the new board and the mushkin?
Q: I was crazy about overclocking today on my T-bird 900 on an Asus A7V, everything was going well with 1911 x 100 multiplier, so I decided to try using 8.0 x 133, my system good start, but when windows loaded it gave me some protection u0026quot; u0026quot, error and told me that I need to get my computer to restart.
Anyone know what the hell is going on?
Q: Hi,
Im using an Asus A7V with BIOS 1003. Asus Probe and MBM 140 reads degrees/60 C for my CPU. My CPU is loaded 100 percent (RC5) 0.
Is this an acceptable temperature? It runs for 20 hours each time and it is very stable so far. So, I think it is OK, but Im not sure